Command: installhigh

  INSTALLHIGH runs a TSR program (a program that stays in memory), without
  an environment, instead of using something like lh or loadhigh.
  INSTALLHIGH loads a TSR program into high memory,whereas INSTALL loads
  the TSR program into low or conventional memory.
  INSTALLHIGH is CONFIG.SYS / FDCONFIG.SYS command.

Syntax:

  installhigh=[drive][path]filename [options]
              drive     The drive letter, e.g. C:
              path      The directory, e.g. \example\
              filename  The filename of the tsr to run, e.g. test.sys

Options:

  options  These are the options which will be passed to the TSR. They are
           not options for the 'installhigh' command.

Comments:

  INSTALLHIGH loads the program specified by drive:\path\filename. It is
  generally used to load TSR (terminate and stay resident) programs with
  a minimal environment block. The options are for the program itself;
  refer to documentation that came with your particular software for
  supported options and usage.
  Since INSTALLHIGH loads the driver into high memory there remains more
  free space in low or conventional memory for other drivers or for
  programs. To load up a driver or a program into high memory you first
  have to load a driver like (HIMEM), HIMEMX or JEMMEX in CONFIG.SYS /
  FDCONFIG.SYS.
  INSTALLHIGH is a command internal to kernel.sys and needs no other file
  in order to work.

Examples:

  IN CONFIG.SYS / FDCONFIG.SYS:
    installhigh=C:\fdos\bin\ctmouse.exe

See also:

  config.sys
  fdconfig.sys
 (fdxms)
 (fdxms286)
 (himem)
  himemx
  install
  jemmex
  lh
  loadhigh

  Copyright © 1998 Jim Hall, updated 2011 by W. Spiegl.

  This file is derived from the FreeDOS Spec Command HOWTO.
  See the file H2Cpying for copying conditions.