Command: break
BREAK sets extended CTRL+C (STRG+C) / Control-Break checking to on
[default] or off. When set to on, the kernel will perform the check
(and invoke current handler if pressed) prior to most int 21h calls.
When set to off, the kernel only performs the check on I/O calls using
standard streams.
BREAK can be used in CONFIG.SYS / FDCONFIG.SYS (see also here)
and while running FreeDOS.
Syntax:
BREAK [ON | OFF] [/?]
Options:
ON CTRL+C (STRG+C) is even tested while an access
to diskette or HD
OFF CTRL+C (STRG+C) is only tested if there is an
output on the screen. Default=OFF
/? Shows the help
Comments:
Type "BREAK" without a parameter to display the current BREAK setting.
If BREAK is ON, programs and commands can always be aborted by typing
CTRL+C (STRG+C).
If BREAK is OFF, programs and commands can only be aborted if you get
an output on the screen.
BREAK can be used in CONFIG.SYS / FDCONFIG.SYS (see also here)
and while running FreeDOS.
BREAK is a command internal to kernel.sys and needs no other file
in order to work.
Examples:
IN CONFIG.SYS / FDCONFIG.SYS / COMMAND LINE:
break on programs can be aborted by CTRL+C (STRG+C)
break off programs cannot be aborted by CTRL+C (STRG+C)
See also:
break config.sys
config.sys
fdconfig.sys
Copyright © 2008 W. Spiegl.
This file is derived from the FreeDOS Spec Command HOWTO.
See the file H2Cpying for copying conditions.